IAI America RCP4W - Manual (Page 54)

4. Maintenance Inspection
48
4.6.2 How to Apply Grease
Grease supply is to be conducted at the grease supply holes on the front cover.
1. “Ball screw/guide supply hole” and “seal supply holes” are covered up with grommets.
Remove the grommets at three points.
2. Move the slider until it stops on the side opposite of the motor.
3. Insert a grease gun to the ball screw/guide supply hole and supply grease to the grease nipple
seen in the hole.
By supplying grease to the grease nipple, grease can be supplied to both the ball screw and
guide.
4. Insert a grease gun at the seal supply holes and apply grease to the seal on the actuator
openings.
5. Move the slider back and forth several times by hand.
6. Attach the grommet.
䎃
Caution: In case the grease got into your eye, immediately go see the doctor to get appropriate
care.
After finishing the grease supply work, wash your hands carefully with water and soap
to rinse the grease off.
Ball Screw/Guide Supply Hole (I8)
Seal Supply Holes (I8)