IAI America RCP4W - Manual (Page 38)

2. Installation
32
If installing on the top surface of the slider, for the calculation of Ma and Mc moments, consider the
position indicated with an arrow as the datum point.
35.0
SA5C
40.0
SA6C
47.5
SA7C
22.5
26.0 27.5
Datum point for
moment calculation
Datum point for
moment calculation
Datum point for
moment calculation
If installing on the bottom surface of the slider, for the calculation of Ma and Mc moments, consider
the position indicated with an arrow as the datum point.
35.0
41.0
SA5C
40.0
47.5
SA6C
47.5
53.0
SA7C
Datum point for
moment calculation
Datum point for
moment calculation
Datum point for
moment calculation
Bottom surface of table Bottom surface of table Bottom surface of table
Caution: An operation beyond the allowable moment and overhang load length would not only
generate abnormal noise and vibration, but also may shorten the life of actuator
extremely.
Ɣ There are tapped holes prepared for attachment of a load on the top, side and bottom surfaces of the
slider. Also, there are two reamed holes. Utilize the reamed holes when repeatability in the
attachment after detaching is required. Also, if you require precision in your attachment, such as a
right angle, use the reamed hole to make fine adjustments.
Ɣ Shown below is the detail of the attachment area. Attach a load with the bolts listed in the table
below with the specified tightening torque.
Top Surface of the Slider
B
Reamed
hole
2-E
C C
A
Reamed Hole Pitch Tolerance: A ±0.02
Tapped
hole
4-D
䎃
䎃
Actuator Type A B C D E
Tapping
Diameter
Tightening
Torque [N•m]
SA5C 35 35 25 M4, depth 6 I 4H7, depth 4 M4 1.76
SA6C 45 45 30 M5, depth 8 I 4H7, depth 5 M5 3.42
SA7C 55 55 35 M5, depth 8 I 4H7, depth 5 M5 3.42
䎃