IAI America RCP2-SRGD4R - Manual (Page 44)

5. Inspection
38
5.4 Grease Supply
5.4.1 Grease to Apply
The actuator is shipped with lithium grease applied to the ball screw.
The following dedicated grease is applied to the ball screw prior to the shipment from our factory.Apart from
above, there are equivalent sorts of grease sold in the market.
Kyodo Yushi Multemp LRL No. 3
5.4.2 Grease supply
When performing maintenance, add grease from the greasing port using a spray-type lithium grease to
lubricate the ball screw.
Lubricate the ball screw after pulling the rod all the way to the stroke end. Stroke the rod several times
back and forth over the entire stroke to let the grease spread evenly across the entire ball screw.
Caution: y Do not attempt to apply fluorine grease.
y When mixed with lithium grease, not only decrease the grease characteristics, but
also may damage the actuator.
y In case the grease got into your eye, immediately go see the doctor to get
appropriate care.
y After finishing the grease supply work, wash your hands carefully with water and
soap to rinse the grease off.
5.5 Replacing the Motor and Belt
If the motor or belt must be replaced, contact IAI.