IAI America RCP2-SRGD4R - Manual (Page 11)

5
No.
Operation
Description
Description
6 Trial Operation Ɣ When the work is carried out with 2 or more persons, make it clear who is to be
the leader and who to be the follower(s) and communicate well with each other
to ensure the safety of the workers.
Ɣ After the teaching or programming operation, perform the check operation one
step by one step and then shift to the automatic operation.
Ɣ When the check operation is to be performed inside the safety protection
fence, perform the check operation using the previously specified work
procedure like the teaching operation.
Ɣ Make sure to perform the programmed operation check at the safety speed.
Failure to do so may result in an accident due to unexpected motion caused by
a program error, etc.
Ɣ Do not touch the terminal block or any of the various setting switches in the
power ON mode. Failure to do so may result in an electric shock or
malfunction.
7 Automatic
Operation
Ɣ Check before starting the automatic operation or rebooting after operation stop
that there is nobody in the safety protection fence.
Ɣ Before starting automatic operation, make sure that all peripheral equipment is
in an automatic-operation-ready state and there is no alarm indication.
Ɣ Make sure to operate automatic operation start from outside of the safety
protection fence.
Ɣ In the case that there is any abnormal heating, smoke, offensive smell, or
abnormal noise in the product, immediately stop the machine and turn OFF the
power switch. Failure to do so may result in a fire or damage to the product.
Ɣ When a power failure occurs, turn OFF the power switch. Failure to do so may
cause an injury or damage to the product, due to a sudden motion of the
product in the recovery operation from the power failure.