Gilderfluke&Co BR-SDC Serial Device Controller - Manual (Page 34)

If this is a Br-SDC8, the commands to select the multiplexed serial port have been
added to the menu:
- Gilderfluke & Co. - Br-SDC Serial Device Controller - ver. 2.13+(c) 2014 DCM -
a) Pioneer CAV, b) 9600 baud, c) clear, d) save, e) shows, f) 30 FPS, 9) mode
h) edit string F, i) edit entry__1, s) Tx value, g) Rx value, u) Rx any, k) kopy
j) Tx Text, q) Rx text, l) dvd search, m) dvd End, T) start Timer, x) string end
n) send eight bit binary, o) send two character HEX, p) send three character BCD
|__1__|__2__|__3__|__4__|__5__|__6__|__7__|__8__|__9__|__10_|__11_|__12_
string1 |serch|_'P'_|_'L'_|_0Dh_|('R')|(0Dh)|LdEnd|_'S'_|_'T'_|_0Dh_|('R')|(0Dh)
string2 |serch|_'P'_|_'L'_|_0Dh_|('R')|(0Dh)|LdEnd|_end_|
string3 |_'S'_|_'T'_|_0Dh_|('R')|(0Dh)|_end_|
string4 |
string5 |
string6 |
string7 |
string8 |
string9 |
stringA |
stringB |
stringC |
stringD |
stringE |
STRINGF |
Enter Command-
- Gilderfluke & Co. - Br-SDC8 Multiport Serial Controller - v2.13 (c) 2014 DCM -
a) Pioneer CAV, b) 9600 baud, c) clear, d) save, e) shows, f) 30 FPS, 9) mode
h) edit string F, i) edit entry__1, s) Tx value, g) Rx value, u) Rx any, k) kopy
j) Tx Text, q) Rx text, l) dvd search, m) dvd End, T) start Timer, x) string end
0) Rx from one and Tx to all, 1-8) Select serial port for both Rx and Tx
|__1__|__2__|__3__|__4__|__5__|__6__|__7__|__8__|__9__|__10_|__11_|__12_
string1 |serch|_'P'_|_'L'_|_0Dh_|('R')|(0Dh)|LdEnd|_'S'_|_'T'_|_0Dh_|('R')|(0Dh)
string2 |serch|_'P'_|_'L'_|_0Dh_|('R')|(0Dh)|LdEnd|_end_|
string3 |_'S'_|_'T'_|_0Dh_|('R')|(0Dh)|_end_|
string4 |
string5 |
string6 |
string7 |
string8 |
string9 |
stringA |
stringB |
stringC |
stringD |
stringE |
STRINGF |
Enter Command-
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Br-SDC Manual / December 30, 2013 9:24 AM / page 34 of 62