Gilderfluke&Co BR-SDC Serial Device Controller - Manual (Page 32)

4) String/Show to play at End:
This allows you to request that a specific show or string will be played at the
successful completion of the string that is being sent. This allows you to jump to
another show, or just send a different string when the main sequence has com-
pleted successfully. Valid input range for this setting is 0 (if no string or show is se-
lected), 1 through 9, A through F (for strings to send), and ʻgʼ through ʻzʼ (for differ-
ent shows to play).
5) String/Show to play on Failure:
This allows you to request that a specific show or string will be played at the
unsuccessful completion of the string that is being sent. String failures are when
you request that a specific character be returned by the device being controlled,
and a different character comes back. This allows you to jump to another show, or
just send a different string when the main sequence has completed failed. Valid
input range for this setting is 0 (if no string or show is selected), 1 through 9, A
through F (for strings to send), and ʻgʼ through ʻzʼ (for different shows to play).
6) Kopy:
This command asks you for the number of another input. When you enter it, the
entire contents of the requested line is copied to the currently selected line.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Br-SDC Manual / December 30, 2013 9:24 AM / page 32 of 62