AMX Modero NXD-500i - Manual (Page 46)

Configuring Communication
40 NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom
8. In some cases, a Connection Details dialog (FIG. 31) may appear that requests a VNC Server IP
Address. This is the IP Address of the target touch panel, not the IP of the Master. Depending on the
method of communication being used, it can be found in either the:
Wired Ethernet - System Connection > IP Settings section within the IP Address field.
Wireless - Not available with the NXD-500i panel.
If this field does not appear, continue to step 9.
9. If a WebControl password was set up on the G4 WebControl page, a G4 Authentication Session
password dialog box appears on the screen within the secondary browser window.
10. Enter the Web Control session password into the Session Password field (FIG. 30). This password
was previously entered into the Web Control Password field within the G4 Web Control page on the
panel.
11. Click OK to send the password to the panel and begin the session. A confirmation message appears
stating "Please wait, Initial screen loading.".
FIG. 30 Web Control VNC installation and Password entry screens
The G4 Web Control application is sent by the panel to the computer that is used for
communication. Once the application is installed, this popup will no longer appear.
This popup will only appear if connecting to the target panel using a different
computer.
FIG. 31 Connection Details dialog
IP Address of touch panel
- obtained from IP Settings section of
the System Connection page