AMX Modero NXD-500i - Manual (Page 135)

Programming
129 NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom
Panel IR Commands
These commands are used to transmit and receive IR signals from the panel. Each panel has up to 4
transmit ports specifically defined as IR output ports. These ports are AMX 38K, AMX 455K, User 1,
and User 2.
^IRM allows the command itself to specify the port number. IRM is needed because commands
programmed on the panel itself can only be sent to a single port number . ^IRS is needed to enable the
received AMX 38K or 455k. In some cases, both of these ports cannot be enabled at the same time.
Panel IR Commands
^IRM
Pulses the given
channel IR
Pulses the given channel IR on for onTime tenths of seconds. Delays offTime tenths of
seconds before the next IR pulse is allowed. The port for the IR is given in the command
itself.
Syntax:
SEND_COMMAND ,"'^IRM-,,,'"
Variables:
None.
Example:
SEND_COMMAND TP1,"'^IRM-,,,'"
SEND_COMMAND TP2,"'^IRM-,,,'"
Specifies the port number to be used.
^IRS
Enable the
received AMX
38K or 455K
Enables the received AMX 38K or 455K. The RX Ir port is given in the command itself.
Syntax:
SEND_COMMAND ,"'^IRS-'"
Variables:
None.
Example:
SEND_COMMAND ,"'^IRS-'"