AMX Modero NXD-500i - Manual (Page 11)

Introduction
5 NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom
Front Bezel Button
The NXD-500i has only one button on the front of the device, in the center of the button trim ring. This
button has several uses:
Press the button once to start a previously programmed function, or to turn off the display if
not previously programmed.
Press and hold the button for 6 seconds to put the device into Setup Mode (please see the Setup
Page section on page 48 for more information).
Press and hold the button for 9 seconds to enter Calibration Mode (please see the Panel
Calibration section on page 21 for more information).
Press and hold the button for 20 seconds to reboot the panel.
Ethernet and mini-USB Ports
The NXD-500i has no power input port. Instead, all power is supplied via the Power over Ethernet (PoE)
protocol. With PoE, the power is supplied directly through the Ethernet port through the PS-POE-AF
PoE Injector, available from AMX. For more information on the PS-POE-AF POE Injector, please refer
to the PS-POE-AF PoE Injector section on page 19.
The mini-USB port is used solely for software upload and audio output. The mini-USB port
automatically detects the presence of a headphone adaptor, allowing the port to be used for headphone
connectivity. For more information on software upgrading, please refer to the Upgrading the Firmware
via the USB port section on page 43.
Specifications for NCXC-500i 5" Widescreen Video Touch Panel (Cont.)
Included Accessories: • NXD-500i Installation Guide (93-2261-02)
• Front Bezel (60-2261-11)
Other AMX Equipment: • CB-TP5i Rough-In/Wallbox (FG038-11)
• Back Cover for CB-TP5i Rough-In/Wallbox (FG038-12)
• PS-POE-AF PoE Injector (FG423-80)
• CC-USB Type-A to Mini-B 5-wire programming cable (FG10-5965)
• USB to Headphone Adaptor (FG5966-23)
• NXA-RK5 Rack Mount Kit for 5" Wall Mount panels (FG2904-55):
- 5" Rackmount
- Four Screws, #10-32 x.625, PH Truss, BLK
- Four Washers, #10, Black Nylon
- Three Screws, #4-40 x.250, PPH, BLK