Ransburg RMA Indirect A11600 - Manual (Page 82)

Slide Item #53 over Item #43 before installing nut and ferrules onto Item #43. After assembly and tightening of nuts
and ferrules, slide Item #53 up against nut at rear most portion of
atomizer assembly.
Lightly coat this area with LSCH0009 dielectric grease. No grease on threads.
Torque fluid tube into atomizer body using tool A11229 to 65-75 lbs•in (7.34-8.47 Nm).
Torque fluid tip using tool A11229 to 25-30 lbs•in (2.83-3.39 Nm).
Tighten set screw in rear plate for F.O. to 5-10 lbs•in (.56-1.13 Nm).
Tighten the break-away ring mounting screws, alternately to a final torque reading of
10-15 lbs•in (1.13-1.7 Nm) (stainless steel). Tighten optional plastic screws 3-5 lbs•in
(.35-.56 Nm).
Tighten bell cups to a final torque of 50-70 lbs•in (5.65-7.91 Nm).
PARTS LIST BULLET DEFINITION TABLE (Figures 59a and 59b)
Figure 60: Bell Cup Parts Breakdown
Figure 61: Bell Cup Styles
Figure 62: Bell Cup Part Numbers/Styles (Part
number is bell cup only - no splash plate included)
65mm Serrated, 65mm (TIS)
65mm Non-Serrated, 65mm (TI)
65mm Serrated, 65mm (TISF)
65mm Non-Serrated, 65mm (TIF)
TYPICAL BELL CUP PARTS BREAKDOWN (Figure 60)
A12069-00
A12070-00
A12076-00
A12474-00
Cup
Only Description
A12071-00
A12071-00
A12071-00
A12071-00
Splash Plate
Assembly
A12086-00
A12086-01
A12087-00
A12087-01
Complete
Assembly
1
2
3
4
Item #
14
13
12
11
10
8
7
2
1
3
A11388-00
SPLASH PLATE
TOOL
1 2 3
RMA-303 Indirect Charge - Parts Identification
Ransburg
78 LN-9252-06.4