Ransburg RMA Indirect A11600 - Manual (Page 72)

Do not attempt to hold a rag or a
gloved hand against the bell edge
to stop or slow down a rotating bell.
Do not attempt to clean the bell
edge while the bell is rotating.
Do not attempt to place a high
voltage probe on the bell edge
unless rotation is full stopped.
Do not reuse an atomizer bell
that shows signs of damage
such as nicks, heavy scratches,
dents, or excessive wear (defined
under "Bell Cup Cleaning" in the
"Maintenance" section).
OPERATOR / MAINTENANCE
***WARNINGS***
Do not attempt to use sharp or
abrasive materials to clean the
bell, which will scratch or damage
the bell.
RMA-303 Indirect Charge - Maintenance
Ransburg
68 LN-9252-06.4