beautypg.com

Ransburg, Splash plate removal, Splash plate insertion – Ransburg RMA Indirect A11600 User Manual

Page 58: Rma-303 indirect charge - maintenance

background image

Splash Plate Removal

After removing the bell cup from the applicator, put

it on a plastic or wood surface to prevent damage

to the edge of the cup. Using the splash plate

removal tool (A11388-00), insert the small end of

the tool into the end of the splash plate assembly.

Press the splash plate out. It may be necessary

to tap lightly with a hammer.

> Failure to tighten the bell cup in place

may cause vibration of the applicator

and/or premature turbine failure.

C A U T I O N

!

Figure 23: Splash Plate Removal

Splash Plate Insertion

Turn the splash plate removal tool over and use

the large diameter end to press the splash plate

back in place by hand. It may be necessary on

occassions to use an arbor press to install the

splash plate. Press splash plate to a hard stop

(see Figure 24).

Care must be taken not to over-press the splash

plate assembly into the bell cup. Damage may

occur.

Figure 24: Splash Plate Insertion

Figure 22: Effective Length Torque Wrench

Example: A desired true torque is desired

using a 9-inch effective length torque wrench.

Wrench offset is 3-inches.

L =

9-inches

TT = 50 lbs•in

E = 3-inches

DR is dial reading.

DR = 50 (9) DR = 37.5 lbs•in

(9+3)

SPLASH PLATE

ASSEMBLY

REMOVAL TOOL

BELL CUP

PRESS

THIS

DIRECTION

FLAT WOOD

OR PLASTIC

SURFACE

CUP

SECTION

VIEW

BELL

CUP

INNER

SURFACE

SPLASH

PLATE

BOTTOM

PRESS

THIS

DIRECTION

FLAT WOOD

OR PLASTIC

SURFACE

RMA-303 Indirect Charge - Maintenance

Ransburg

54

LN-9252-06.4