General Pump MW Repair Manual - Manual (Page 50)

GENERAL PUMP
A member of the Interpump Group
MW/S SERIES
Insert the Ø10 x 18 x 0.9 washer in the plunger fixing screw (1, fig. 182).
Position the spray hood in the plunger guide housing (1, fig. 181).
Page 50
Install the plungers on their respective guides (1, fig. 183) and fasten them as per 1, fig. 184.
Calibrate the screws with a torque wrench as indicated in paragraph 3 “Screw Tightening Calibration”.
Ref 300791 Rev.C
11-12