General Pump MW Repair Manual - Manual (Page 17)

GENERAL PUMP
A member of the Interpump Group
MW/S SERIES
Fully insert the shaft in the casing (1, fig. 50 and fig. 51).
Page 17
Pre-assemble the outer ring of the pinion bearing on the reduction gear with the aid of special tool
#F27604900 (1, fig. 52), inserting fully down to end stroke (1, fig. 53).
From the opposite side of the reduction gear box, pre-assemble the external ring of the crankshaft bearing
with the use of tool #F27605000 (1, fig. 54), inserting fully down to end stroke (1, fig. 55).
Ref 300791 Rev.C
11-12