General Pump MW Repair Manual - Manual (Page 18)

GENERAL PUMP
A member of the Interpump Group
MW/S SERIES
Repeat this operation on the bearing box, pre-assembling the external crankshaft bearing ring with the help of
special tool #F27605000 (1, fig. 56), inserting fully down to end stroke (1, fig. 57).
Page 18
Insert the side seal on the bearing cover (1, fig. 58) and lift the crankshaft to favor cover insertion
(1, fig. 59).
Assemble the bearing cover (and relative seal) using an extractor hammer (1, fig. 60).
Position the bearing cover in such a way that the “Pratissoli” logo is perfectly
horizontal.
Ref 300791 Rev.C
11-12