General Pump MW Repair Manual - Manual (Page 19)

GENERAL PUMP
A member of the Interpump Group
MW/S SERIES
Tighten the 8 M10 x 30 screws (1, fig. 61). Calibrate the screws with a torque wrench as indicated in
paragraph 3 “Screw Tightening Calibration”.
Page 19
From the opposite side, insert the side seal on the reduction gear box 91, fig. 62) and lift the crankshaft to
favor cover insertion (1, fig. 63).
Assemble the reduction gear box (and relative seal) using an extractor hammer (1, fig. 64).
Ref 300791 Rev.C
11-12