General Pump 66 Series HTF, TSF & TSP Crankshaft Flip - Manual

HTF, TSF & TSP Series 66
GENERAL PUMP
A member of the Interpump Group
TR
IP
LE
X
TR
IP
LE
X
Triplex Plunger Pump
CRANKSHAFT “FLIP” INSTRUCTIONS
CRANKSHAFT FLIP PROCEDURES
General Pump
is a member of
the Interpump Group
8
Ref 300887 Rev. A
05-12
1) Drain crankcase oil.
2) Remove qty. 4 rear cover screws with 5 mm hex wrench.
Fig. 1
3) Remove connecting rod cap bolts with 6 mm hex wrench,
respecting position and orientation of each cap. Position
connecting rod/plunger guides fully into crankcase to
allow clearance of crankshaft removal. Fig. 2 and 3.
4) Remove qty. 4 each bolts retaining side covers with
6 mm hex wrench. Fig. 4 and 5.
Fig. 1
Fig. 2
Fig. 3
Fig. 4