General Pump MW Repair Manual - Manual (Page 10)

GENERAL PUMP
A member of the Interpump Group
MW/S SERIES
Page 10
Slowly screw in the 3 M8 screws (1, fig. 24) to prevent the box from tilting too far and getting locking in the
housing. Remove the box while supporting the shaft to prevent damage (1, fig. 25)
Unscrew the bearing cover fixing screws from the opposite side (1, fig. 26 and fig. 27).
Position the 3 grub screws or M8 threaded screws (1, fig. 23) with the function of extractors in the holes and
two sufficiently long M10 screws with the function of supporting the reduction gear box (2, fig. 23).
Ref 300791 Rev.C
11-12