General Pump MW Repair Manual - Manual (Page 21)

GENERAL PUMP
A member of the Interpump Group
MW/S SERIES
Page 21
After finishing this operation, verify that the con-rods have axial clearance in both
directions.
Insert the plunger guide seal rings in their casing housing by means of a special tool #F27605300
(1, fig. 70).
Insert the O-ring on the rear cover (1, fig. 71) and assemble the cover on the casing with the aid of 6
M10 x 30 screws (1, fig. 72).
Ref 300791 Rev.C
11-12