General Pump MW Repair Manual - Manual (Page 24)

GENERAL PUMP
A member of the Interpump Group
MW/S SERIES
From the other side of the pinion, pre-assemble the bearing 55 x 120 x 29 (1, fig. 82) positioning it to end
stroke using tool #F27604800 (1, fig. 83).
Insert the bearing support ring (1, fig. 84) and position the retaining ring Ø55 (1, fig. 85).
Insert the pinion pre-assembled inside its housing in the reduction gear cover, with the aid of an extractor
hammer (1, fig. 86).
Page 24
Ref 300791 Rev.C
11-12