Agilent Technologies N5183A MXG - Manual (Page 65)

Agilent N518xA, E8663B, E44x8C, and E82x7D Signal Generators Programming Guide 55
Using IO Interfaces
Using USB (Agilent MXG)
Setting Up the USB Interface
Rear Panel Interface (Mini–B 5 pin)
To use USB, connect the USB cable (Refer to Table 2- 3, “USB Interface Cable,” on page 55 , for USB
cable information.) between the computer and the signal generator’s rear panel Mini- B 5- pin USB
connector.
Front Panel USB (Type–A)
For details on using the front panel USB (Type- A) and the front panel USB Media operation, refer to
the User’s Guide.
Using the Internal Storage and USB Media (Non-volatile Memories)
For details on using the internal storage and the front panel USB Media operation, refer to the User’s
Guide.
Table 2-3 USB Interface Cable
Quantity Description Agilent Part Number
1 USB cable Mini- B 5 pin to Type- A 82357- 61601