Teledyne 9110AH - Nitrogen oxides analyzer - Manual (Page 90)

TELEDYNE Model 9110AH NO
X
Analyzer Operator Manual, 01620, Rev. F
7-2
Table 7-1: Types of Zero/Span Check and Calibration
Section Type of Cal or Check Description
7.1 Manual Z/S Check or Calibration with
span gas in the sample port This calibration method uses calibration gas
coming in through the sample port. Zero/Span
valves do not operate.
7.2 Manual Z/S Check or Calibration with
Z/S Valve Option. How to operate Zero/Span Valves Option. Can
be used to check or adjust calibration.
7.3 Dynamic Z/S Calibration with Z/S
Valves Option Operates Z/S valves periodically and adjusts
calibration.
7.4 Use of Z/S Valves with Remote
Contact Closure Operates Z/S valves with rear panel contact
closures. Without valves, can be used to switch
instrument into zero or span cal mode. Used for
either checking or adjusting zero/span.
7.5 NO Only Mode Calibration Covers requirements if calibrating in NO only
mode.
7.6 NO
x
Only Mode Calibration Covers requirements if calibrating in NO
x
only
mode.
7.7 Calibration Requirements for
AutoRange or Remote range Covers special requirements if using AutoRange
or Remote Range control.
7.8 Calibration Requirements for
Independent Ranges Covers special requirements if using Independent
Range
7.9 Calibration Quality Information on how to determine if the
calibration performed will result in optimum
instrument performance.
7.10 Converter Efficiency Compensation Covers methods to automatically compensate for
converter efficiency.