Teledyne 9110AH - Nitrogen oxides analyzer - Manual (Page 29)

TELEDYNE Model 9110AH NO
X
Analyzer Operator Manual, 01620, Rev. F
3-1
3 SPECIFICATIONS, WARRANTY
3.1 Specifications
Operating Modes NO/ NO
x
switching mode, NO only mode, NO
x
only mode
Ranges In 1 ppm increments from 5 ppm to 5,000 ppm
Single range, independent ranges or autoranging
Noise at zero 0.02 ppm RMS
Noise at span <0.2% of reading RMS above 20 ppm
Detection Limit(Note 1) 0.04 ppm RMS
Zero Drift (Note 2) <0.2% full scale/24 hours
Zero Drift (Note 2) <0.4% full scale/7 days
Span Drift (Note 2) <1% FS/24 hours
Lag Time
Switching Mode 20 sec (Note 3)
NO
x
mode 4 sec (Note 3)
Response Time
Switching Mode 95% in < 40 sec (Note 3)
NO
x
mode 95% in < 10 sec (Note 3)
Sample Flow Rate 290 10 cc/min (Including bypass)
Linearity 1% of full scale
Precision 0.5% of reading
Temperature Range 5-40
o
C
Humidity 0-95% RH non-condensing
Temp Coefficient < 0.1% per
o
C
Voltage Coefficient < 0.1% per V
Dimensions HxWxD 7"x17"x23.6" (18 cm x 43 cm x 61 cm)
Weight, Analyzer 43 lbs (20 kg)
Weight, Pump Pack 16 lbs (7 kg)
Power, Analyzer 100 V~ 50/60 Hz, 120 V~ 60 Hz, 220 V~ 50 Hz, 240 V~ 50 Hz, 200 watts
Power, Analyzer 4 230 V~ 50 Hz, 2.5A
Power, Ext Pump 110 V~ 60 Hz, 220 V~ 50 Hz, 240 V~ 50 Hz, 295 watts
Power, Ext Pump 4 230 V~ 50 Hz, 2.5A
Environmental Installation Category (Over-voltage Category) II
Pollution Degree 2
Analog Resolution 1 part in 2048 of selected voltage or current range
Recorder Output 0-100 mV, 0-1, 5, 10v, bipolar
Current Loop Option 4-20ma isolated
Status 12 Status Outputs from opto-isolator
Measurement Units ppm, mg/m 3
1. Defined as twice the zero noise level.
2. At constant temperature and voltage.
3. Lag & response times longer for external converter option.
4. Electrical ratings for CE Mark compliance.