Teledyne 9110AH - Nitrogen oxides analyzer - Manual (Page 82)

TELEDYNE Model 9110AH NO
X
Analyzer Operator Manual, 01620, Rev. F
5-40
Where:
name = name of the variable
value = current value of variable
warning_lo = lower limit warning (displayed if applicable)
warning_hi = upper limit warning (displayed if applicable)
data_lo = lower limit of allowable values
data_hi = upper limit of allowable values
Variables can be changed. Before changing the settings on any variables, please make sure you
understand the consequences of the change. We recommend you call the factory before
changing the settings on any variables. The general format for changing the settings on a
variable is:
V LIST name[=value [warn_lo [warn_hi]]]
For example to change the warning limits on the box temperature type:
V BOX_SET 30 10 50
and the CPU should respond with:
V DDD:HH:MM IIII BOX_SET=30 10 50(0-60)
The CONFIG command lists the software configuration.
For example:
V CONFIG list software configuration
The format of this listing is shown in the example below.
CONFIG[0] = Revision H.7
CONFIG[1] = NO
x
Analyzer
CONFIG[2] = SBC40 CPU