Teledyne 9110AH - Nitrogen oxides analyzer - Manual (Page 64)

TELEDYNE Model 9110AH NO
X
Analyzer Operator Manual, 01620, Rev. F
5-22
5.3.9 Variables Menu (VARS)
This menu enables you to change the settings on certain internal variables. The VARS are
defined in Table 9-5 which is located in the Troubleshooting Section 9.1.4.
5.4 M9110AH Operating Modes
The M9110AH has two main operating modes. The instrument is normally in SAMPLE mode
when it is taking data or doing a calibration. The second main mode is the SETUP mode. In this
mode the many features of the instrument can be altered, enabled or disabled. Within these two
main modes there are many other operating modes which are shown in Table 5-7. The mode
the instrument is operating in is shown in the upper left of the front panel display.