beautypg.com

Operation, Assembling the mill, Grinding grain – Bosch MUZXLVE1 VitalEmotion pour les maîtres du pain le kit VitalEmotion est composé dun moulin à céréales dun mini-hachoir Multi-mixer et de 3 disques User Manual

Page 8: After using the appliance

background image

8

Robert Bosch Hausgeräte GmbH

Operation

Thoroughly clean the mill before using

for the first time, see “Cleaning and

servicing”.

Assembling the mill

Fig. 

Turn the adjusting ring until the marks

on the adjusting ring and housing are

in alignment (-1).

Place the grinding cone on the square

shaft in the housing (-2).

Insert grinding ring (-3).

Arrow on the grinding ring must point

towards the marks on the adjusting

ring and on the housing!

Only in this position can the grinding ring

be inserted correctly.

Depress grinding ring slightly and turn the

adjusting ring clockwise into the grinding

area (-4).

Attach filling container (-5).

Grinding grain

Fig. 

Attention!

If the food processor is not used with

the original bowl, the tool drive cover must

be attached, otherwise the appliance will

not start. If the tool drive cover is attached,

the original bowl cover cannot be attached.

Press release button and move

multi-function arm to position 2.

Insert the bowl:

– Tilt the bowl forwards and then

set it down.

– Turn anti-clockwise until it locks

into place.

Press release button and move

multi-function arm to position 1.

Remove drive cover from the mill drive

(-5a).

Cover unused drives with drive covers.

Attach mill and turn all the way to the left.

To prevent excessive dust formation

when grinding, put the lid on the bowl.

– Press release button and move multi-

function arm to position 2.

– Attach the cover.

– Move multi-function arm back

to the operating position.

Tip: If required, the lid opening can also

be covered with a cloth.

Set required degree of grinding on the

adjusting ring.

Steplessly from 1 (= fine) to 6 (= coarse).

The degree of grinding can be changed

even while the grinder is running.

Note: In direction 1 (= fine) set the degree

of grinding only in small steps to prevent

the grinder from becoming blocked.

Pour the ingredients into the filling con-

tainer.

Max. quantity: 750 g

the marks in the filling container are

a guide and refer to wheat.

Insert the mains plug.

Set rotary knob to setting 7.

To prevent the ingredients from over-

heating, setting 5 can be used for a very

fine degree of grinding.

After using the appliance

Switch off the appliance with the rotary

switch.

Remove mains plug.

Rotate the mill in an anti-clockwise

direction and remove.

en

Important information

In these instructions for use the recom-

mended reference values for the operating

speed refer to appliances with a 7-setting

rotary switch.

For appliances with a 4-step rotary

switch the guide values can be found

in the following table:
7 settings: 1...2...3...4...5...6...7

4 settings: 1........2........3........4

Important information

Max. 2 kg of ingredients can be proces-

sed in one grinding process to prevent

the appliance from overloading.

Then leave the appliance to cool down

for at least 1 hour.