Diamond Products FZ - Manual (Page 5)

Hazard Safety clothing
falling parts: helmet, hard-toed
boot
moving,
sharp-edged parts:
gloves
flying sparks and
pieces: safety glasses
slipping: antislipping shoes
noise: ear protectors
contamination of
airways:
mask
Materias to be machined
Only th e f ollo win g ma te ria ls a re to be mac hin ed by
HYDROSTRESS-equipment:
•
Concrete and stone
Other materials are not to be machined. Especially avoid machi-
ning:
– Wood, plastic or glass
Cutouts and drilling cores
These pieces can be very heavy.
Example:
A cube of concrete measuring 0.5 by 0.5 by 0.5 meters weighs
about 300 kg. A drilling core with a diameter of 30 cm and a lenght
of 1 meter weighs about 180 kg.
Make sure that these pieces can not fall or tip over and cordon off
the hazardous area!
Safety devices
Never run the machine without correctly mounted safety devices
(see "safety devices" in this manual)!
Power units and accessories
Use the machine exclusively together with the recommended
power units and accessories (see "connectable units" and "acces-
sories" in this manual).
Local safety regulations
Pay attention to the safety regulations of your local branch as-
sociations!
1.2 Before machining
Emergency stop
Make sure that you know how to stop the machine immediately
(see "Emergency stop")!
First aid
Find out where to get help in case of an accident!
Supply lines
Make sure that all supply lines are turned off in your machining
area! Find out whether such lines may be cut through!
Reinforcement
Find out whether the reinforcement in your machining area may
be cut.
Manage your work place
Manage your work place well! This helps prevent accidents effecti-
vely.
Lighting of the work place
Ensure sufficient lighting of your workplace.
FZ Safety instructions
FZ30494E Page 5