Diamond Products FZ - Manual (Page 3)

0.5 Table of contents
0.1 Introduction 2
0.2 Validity of this manual 2
0.3 Technical standards 2
0.4 Delimitation of system 2
0.5 Table of contents 3
1 Safety instructions 4
1.1 Fundamentals 4
1.2 Before machining 6
1.3 During sawing 7
1.4 After machining 7
2 Technical data 8
2.1 Dimensions (Text) 8
2.2 Dimensions (Figure) 8
3 Range of application 9
3.1 Connectable units 9
3.2 Possible applications 9
4 Design and function 10
4.1 Design of wall saw system 10
4.2 Safety devices 10
4.3 Track system 10
4.4 Design wall saw head 10
4.5 Function 12
4.6 Operating elements and connections 14
5 Set-up 16
5.1 Initial set-up 16
5.2 Preparatory operations 16
5.3 Choosing the saw blade 18
5.4 Choosing the saw motor 20
5.5 Changing the saw motor 22
5.6 Fixing the tracks on concrete 23
5.7 Mounting the wall saw head 24
5.8 Mounting blade and blade guard or
flush cutting flange
24
5.9 Connecting the power unit 26
6 Sawing 27
6.1 Before sawing 27
6.2 The first cut 27
6.3 After the first cut 28
6.4 End of machining 29
7 Troubleshooting 30
8 Maintenance 32
8.1 Maintenance table 32
8.2 Checking tension of toothed belt 33
8.3 Tensioning the toothed belt 33
8.4 Replacing guiding devices 33
8.5 Replacing feed motor 34
8.6 Replace swivelling motor 34
8.7 Refilling lubricant 34
9 Repairing 36
10 Transport, placing out of service,
storing, disposal
37
10.1 Transport 37
10.2 Placing out of service and storage 37
10.3 Disposal 37
11 Accessories 39
12 Spare parts list 40
12.1 Order indications 40
12.2 Table of contents (Spare parts) 41
FZ
FZ30494E Page 3