Diamond Products FZ - Manual (Page 29)

6.4 End of machining
1) Turn off power unit and unplug mains
2) Relieve pressure from the hydraulic
circuits
3) Clean wall saw system, e.g. by ho-
sing it down
4) Remove blade guard
5) Remove saw blade and keep
screws safely or screw them back
into holes
6) Disconnect hoses
– Turn the locking ring
– Hold the hose end in straight position
– Push the coupling sleeve back
– Remove the hose
– Connect both ends of the hose package
in order to keep the couplings clean and
protect them from damage during trans-
port
7) Unscrew the guide grips completely
8) Remove the wall saw head
9) Remove the tracks
FZ Sawing
FZ30494E Page 29