Micromod Micro-DCI: 53HC2600 LoopMaster SL6000 CONFIGURATION TOOLKIT - Manual (Page 20)

53HC2600 INSTRUCTION MANUAL
12 Installation
• If you clicked the Browse button, enter both the drive and directory you want to use as the
destination directory in the Choose Directory field.
• If the directory does not exist, Setup will ask you if it should be created. If this window
appears, click the Yes button.
• Click the Next button.
• The Setup window progress bar reactivates and the Micro-DCI files begin to install.
11. Installing the LoopMaster license key
Setup will launch the Micro-DCI License Administration window to enter your license keys.
• If the loopmaster license key was entered during Item 8, it need not be entered again.
Close the window by clicking on the close button in the upper right-hand corner of the win-
dow.
• If the LoopMaster License Key has not been entered previously, select Add new
license... from the License menu.
• In the License Administration dialog, type in your license information for one license key.
Be certain to enter all information exactly as it appears. Click Save and this information
will be verified and written to the license file. If the information entered is not correct, a
pop-up message box will appear and the information will have to be corrected.
The following license key is used:
loopmaster - licenses all product features
• When finished, select Exit from the File menu.
12. Select Program Folder
The Select Program Folder window appears. Select the program Folder you want the program
icons added to. The LoopMaster folder is selected by default as the folder for the program
icons. You can accept the default, select an existing program folder, or type a new program
folder.
• Click the Next button.
13. New Program Folder
• The LoopMaster Setup program then creates the LoopMaster program folder and auto-
matically adds the appropriate icons for the LoopMaster product.
14. Integrating Into Super32
• LoopMaster can be registered to be the default configuration program for SL6000 control-
lers in the Super32 Micro-DCI network management utility.
• When asked if LoopMaster should be integrated into Super32, select Yes to register Loop-
Master as the default configuration program or No to use the Super32’s basic SL6000
configuration program.
15. Finishing the Installation
✎ NOTE
If the Micro-PWC software has been installed, the Micro-PWC
Maintenance Utility window will appear instead of the Micro-DCI
License Administration window