Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller CUSTOMIZATION GUIDE - Manual (Page 76)

F-CIM 74
SETPOINT GENERATOR - 3
NOT REUSABLE
NAME SYMBOL DATAPOINT
INPUTS
S n-1 REMOTE SETPOINT RSP3 C228
A REMOTE SP ENABLE RE3 L187
B SETPOINT TRACK INPUT STV3 C236
C SETPOINT TRACK SWITCH SWSPT3 L188
PARAMETERS SETPOINT TRACK ENABLE STE3 L190
REMOTE GAIN K13 C221
REMOTE BIAS B13 C220
INSTRUMENT RANGE IR3 C223
SETPOINT HI LIMIT SH3 C233
SETPOINT LOW LIMIT SL3 C234
OUTPUTS
S
n
SETPOINT SP3 C209
SETPOINT TRACK STATUS SPTS3 L176
REMOTE STATUS RMT3 L180
REMOTE SWITCH SWR3 L185
Description:
This module selects one of three signals to load into SP and become its output
(S
n
). The signal selected is either the Setpoint Tracking Value (B), the Remote
Setpoint Value (S
n-1
) multiplied by K1 and biased by B1, or the Setpoint pushbut-
ton value. If the Setpoint Track Switch (C) is less than 1, then S
n
=B when Setpoint
Tracking is enabled (STE=1). When the previous condition is not in effect S
n
will
equal S
n-1
x K1 + B1 if RemoteEnable (A) is greater than or equal to 1 and the
R/L pushbutton has set Remote Switch to1. When none of the previous conditions
are in effect the selected signal comes directly from the setpoint increase and de-
crease pushbuttons.
MODULAR CONTROLLER CUSTOMIZATION GUIDE
3-24