Laurel Electronics LAUREATE SERIES 2 COUNTER-TIMER-SERIAL INPUT METER - Manual (Page 36)

36
Press
Menu Press Digit
Select Key Press Value Select
Key
_00000 & _00000 0 Not used with VF Batch. Set to 0.
_00000
Batch triggering
0 Use gate time* as delay between batches.
1 Use External Input B to start each new batch.
_00000
Definition of Item #2
0 Make Item #2 the Grand Total of all batches.
1 Make Item #2 the Total Number of batches.
bAtCH
Batch setup
_00000
Action after Meter Reset
0 Display “rEAdy.” RESET key starts batching.
1 Start batching upon Meter Reset.
_00000
Signal filtering
0 Adaptive moving average filter. Restarts filter for
high actual changes in signal.
1 Conventional moving average filter without reset.
_00000
Peak & Valley filtering
0 Peak* or Valley* value from unfiltered signal.
1 Peak* or Valley* value from filtered signal.
_00000
Display filtering
0 Display value of unfiltered signal.
1 Display value of filtered signal.
_00000
Adaptive filter setup
0 Set adaptive filter for normal noise.
1 Set adaptive filter for presence of high transients.
FiLtEr
Filtering
_00000
Filter time constant
0 No filter 1 0.1 sec 2 0.2 sec 3 0.4 sec
4 0.8 sec 5 1.6 sec 6 3.2 sec 7 6.4 sec
dEC.Pt1
Decimal pt1
1
.
11111
Decimal point flashes.
1
.
11111 11
.
1111 111
.
111 1111
.
11 11111
.
1 111111
.
Press to shift the decimal point.
dEC.Pt22
Decimal pt2
2
.
22222
Decimal point flashes.
2
.
22222 22
.
2222 222
.
222 2222
.
22 22222
.
2 222222
.
Press to shift the decimal point.
Scale and Offset scaling method if selected under SEtuP
SCALE1
Scale
Factor 1
0.00000 0.00000 0.00000
0.00000 0.00000 0.00000
Select the digit to flash
for the Scale Value, then
press one more time
for the Scale Multiplier.
Select -9 thru 9 for flashing first digit and 0 thru 9 for
other flashing digits. This will set the Scale Value*
from -9.99999 to 9.99999 with a fixed decimal point.
Then press to select a value from
0.00001 to
100000 in decade steps for the Scale Multiplier.
Scale Factor = Scale Value x Scale Multiplier.
OFFSt1 .
Offset 1
000000 000000 000000
000000 000000 000000
Select digit to flash.
Select -9 thru 9 for flashing first digit and 0 thru 9 for
other flashing digits. Use dEC.Pt1 to set the decimal
point.
SCALE2 Scale Factor 2. Make the same Scale Factor 1.
OFFSt2 . Offset 2. Make the same as for Offset 1.