Laurel Electronics LAUREATE SERIES 2 COUNTER-TIMER-SERIAL INPUT METER - Manual (Page 11)

11
RESET Key. Pressing RESET with PEAK resets peak and valley values. Pressing
RESET with ALARMS resets latched alarms. Pressing RESET with MENU performs a
meter reset (same as power on). Pressing and releasing RESET without pressing
another key changes the displayed item if the mode has multiple items. For Item 1, the
V LED is out. For Item 2, the V LED is on. For Item 3, the V LED is flashing.
ALARMS Key. Pressing ALARMS once displays the setpoint for Alarm 1. Pressing it
again displays the setpoint for Alarm 2. Pressing it again returns to the present value.
After 30 seconds, the meter automatically returns to the present value. Timing is
automatically reset whenever the ALARMS key is pressed.
KEYS IN MENU MODE
Right Arrow Key (MENU). Pressing
steps the meter through all menu items that
have been enabled and then back to the Run Mode. With the dual-channel pulse input
signal conditioner board and no option boards, available menu items will be _
InPut ,
SEtuP , ConFiG , dSPYno , etc. Actual menu items will vary depending on the Input
selection and boards detected in the meter. If a change has been made to a menu item,
that change is saved to non-volatile memory when the
key is pressed next, and
_ StoreE is displayed briefly.
Right Triangle Key (Digit Select).
• Pressing from the InPut menu brings up all meter functions available with the
meter's signal conditioner. For the dual-channel pulse input signal conditioner, these
are _
rAtE _, PEriod , _ totAL , ti_Int , Stop _ t , _ PHASE , duty _ C .
• Pressing from most menus selections sequentially selects digit positions 1 - 6, as
indicated by a flashing digit: 000000 , 000000 , 000000 , 000000 , 000000 , 000000 .
• Pressing from dEC.Pt1 brings up a decimal point display of type 11.1111 . Pressing
from dEC.Pt2 brings up a decimal point display of type 22.2222 .
Up Triangle Key (Value Select).
• Pressing from a selected meter function, such as _
rAtE _, will select the a specific
operating mode within that function, such as A_OnLy . Always press the MENU key
to save your selection. Do not press the key to the right, or your selection will be
lost.
• Pressing for a flashing digit position or decimal point position will increment that
item. Pressing the MENU key will save any changes.
Left Arrow Key (Reverse Menu). Pressing has the same effect as the MENU key,
except that menu items are brought up in reverse order.