Impulse 463N - Manual (Page 83)

©Sealevel Systems, Inc.
SL9049 - 11/2010
SeaI/O Manual 83
The SeaI/O-470 module ships factory configured with the D/A outputs set for 0-10V and current
loop mode on the A/D inputs disabled. If you need to enable current loop mode or set the D/A
outputs to 0-5V, you will need to open the enclosure and access the jumpers (shown on the next
page).
Do not perform these instructions with the power connected. Be sure to follow proper ESD
procedures by grounding yourself and the SeaI/O module.
 SeaI/O-470 module
 Phillips head screwdriver
 Slotted screwdriver
Remove the terminal block from the left side and
then remove the two black screws from each side
of the module as shown in the image.
On the front right side of the module, wedge a
slotted screwdriver between the top and bottom
halves as shown. Pry upwards – a pem in the top
half must clear the metal lip in the bottom half of
the enclosure.
Jumpers and dipswitch locations are shown on the
following page.