Impulse 463N - Manual (Page 62)

©Sealevel Systems, Inc.
SL9049 - 11/2010
SeaI/O Manual 62
To confirm that the IP Address for your wireless adapter was changed successfully, reopen
Ethernet Config (Start  All Programs  Sealevel SeaMAX  Ethernet Config).
You should now see the wireless SeaI/O module‟s „Name‟ listed (“DemoUnit” in this example).
This indicates that your wireless adapter and the wireless SeaI/O module are on the same
subnet and you are now able to communicate with the wireless SeaI/O module.
Do not make any changes to the „Device Network Settings‟ at this point. You must complete
the Wireless Configuration first.
Verify that you can communicate with the wireless SeaI/O module by clicking the “Wireless
Configuration” button.