Impulse 463N User Manual
Page 56
©Sealevel Systems, Inc.
SL9049 - 11/2010
SeaI/O Manual
56
Verify that SeaMAX software has been installed successfully and that a wireless SeaI/O module
is connected to power and ready to be configured to communicate with your wireless network.
This module will become the “base” module.
To configure a wireless SeaI/O module, you must be using a laptop or desktop computer
with a wireless 802.11b/g compatible adapter. The security settings on many wireless
access points (WAP) prevent you from seeing Ad Hoc devices by default. Therefore,
configuring a wireless SeaI/O module through a Wireless Access Point (WAP) is not
supported.
1. Using a wireless enabled computer, connect to the Ad Hoc network “SL_Recovery”.
2. Move your wireless adapter to subnet 192.168.0.x.
3. Use the Ethernet Config utility to configure the wireless SeaI/O module to work with
your wireless network (SSID, topology, channel, and security) settings.
4. Using the same wireless enabled computer, connect to your wireless network.
5. Use the Ethernet Config utility to configure the wireless SeaI/O module to use the
same subnet as your wireless network.
6. Move your wireless adapter back to your wireless network subnet.
7. Use MaxSSD to configure the Slave ID of the wireless SeaI/O module and test
settings.
The detailed configuration instructions that follow are for Windows XP. The basic instructions
for Windows 2000 are the same. If you have any questions, please contact Sealevel technical
support at