Impulse 463N - Manual (Page 81)

©Sealevel Systems, Inc.
SL9049 - 11/2010
SeaI/O Manual 81
Remove the terminal block from the left side and
then remove the two black screws from each side
of the module as shown in the image.
On the front right side of the module, wedge a
slotted screwdriver between the top and bottom
halves as shown. Pry upwards – a pem in the top
half must clear the metal lip in the bottom half of
the enclosure.
Remove the two screws from the metal strain
relief, as shown.
Remove the three screws from the bottom of the
module and remove the front plate.
Install up to four industry standard ribbon cables
in the 50-pin header connectors. A list of optional
cable part numbers is listed on the previous page.
Replace the front plate and install the three screws
in the bottom of the module as shown.