Impulse 463N User Manual

Page 70

©Sealevel Systems, Inc.
SL9049 - 11/2010

SeaI/O Manual

Set the slave ID of the “base” wireless SeaI/O module using the rotary switch or software
selection method discussed in the Setting Device Address section (MaxSSD chapter) of this
manual. This guarantees that any expansion modules connected next will not conflict with the
“base” module. Perform another Get operation to verify that you can communicate with the
“base” wireless SeaI/O module at the new slave ID.

Configure the SeaI/O modules one at a time. Set the address to a hardware slave ID other
than “0” or a software slave ID other than 247, to avoid device conflicts during setup.

After the “base” wireless SeaI/O module is successfully communicating via MaxSSD, you can
proceed with adding SeaI/O expansion modules (N-series). Refer to the Configuring Expansion
Modules section of this manual.

This manual is related to the following products:

540N 470N 530N 570N 463W 540W 530W 420M 530M 450M 430M 440M 540M 462M 463M 520U 420U 530U 450U 430U 440U 540U 462U 463U 520S 420S 410S 450S 430S 540S