Controlled Products Systems Group 222EX43 - Manual (Page 3)

800-321-9947 www.hysecurity.com D0482 Rev B Page 1
Manual addendum SlideDriver , SlideDriver 50VF series
May 30, 2012 D0125 Rev H D0119 Rev J
Notifications
Screen Mesh on Gate Height: Per UL 325 and ASTM 2200 Standards, all openings in a sliding gate up to a 72-inch (6
foot or 183 cm) height must be guarded or screened. Note that all references to the 48-inch (4ft or 122 cm) screen mesh
height in the manual are incorrect.
New Products from HySecurity
Advance Drive™ Wheel System: HySecurity has developed a 6-inch
composite drive wheel and improved mounting system that is replacing the cast
polyurethane wheels. For more information, refer to the Technical Bulletin on
the HySecurity website. Installation Instructions are shipped with the
replacement wheels. Plans are in place for 8-inch wheel availability by year end.
XtremeDrive™ Option: The XtremeDrive option for HySecurity SlideDriver operators consists of a cogged lower
wheel that engages a matching cogged rack which is mounted to the underside of the
drive rail. This configuration produces better pull force for large, heavy gates and provides
better traction the entire length of the drive rail.
The XtremeDrive is available in 6-
and 8-inch drive wheel
kits that contain
installation instructions.
The Rack Kit provides
one 25-inch rack and
the required hardware
for installation. A
onetime purchase of an
Install Kit provides a
drill jig, countersink bit, and transfer punch for easy installation.
HySecurity Upgrades
Software: The latest software release for HySecurity operators is now available at
www.hysecurity.com. To update your operators and electronic boards, download
the following from our website:
 Smart Touch Analyze and Retrieve Tool (S.T.A.R.T. software)
 Smart Touch Controllers (STC) operator code
NOTE:
outdated versions of the S.T.A.R.T. application on your PC (laptop) and uploading the latest version of S.T.A.R.T.
and operator code onto it for use in the field . If you are using an outdated version of S.T.A.R.T. with a newly
installed operator, an AL22 alert code may appear. To clear the alert code, you need to access the Installer Menu and
make sure the sequential gate (SG) menu item is set to 0.