Clear-Com HX System Frames - Manual (Page 56)

The following status information is displayed:
Status information Description
System Status This field shows the status of any data download from a
connected PC computer operating the EHX software. When
data downloads to the Eclipse HX-PiCo matrix from a
connected PC, either Serial Download or Ethernet
Download is displayed to indicate the type of download.
When the download ends, OK is displayed in the System
Status field.
PiCo-Link Shows the status of the PiCo-Link, a high capacity link for
connecting two Eclipse HX-PiCos.
When an X is displayed in the UP checkbox, the high-speed
link is connected. When an X is displayed in the Activity
checkbox, the high-speed link is receiving information.
Local Area Network Shows the status of a local area network, if one is
connected. When an X is displayed in the UP checkbox, the
LAN is connected. When an X is displayed in the Activity
checkbox, the LAN is receiving information.
Table 17: System status information
5.9 Selecting a source of Identification Tone
An Identification Tone (Ident Tone) is typically sent to destinations that require a tone or audio
statement during system setup. This feature is activated from the Audio menu’s output level screen
(see 5.3 Adjusting audio levels).
To use this feature, a source for the Identification Tone must be selected. To select a source for the
Identification Tone:
1. From the Main menu, select System. The System menu is displayed.
2. From the System menu, select Maintenance. The Maintenance menu is displayed.
3. From the Maintenance menu, select Ident Source. The Ident Source menu is displayed.
4. Scroll to the Source number and press the setup/enter rotary control.
5. Rotate the setup/enter rotary control clockwise or counterclockwise to scroll through the
available digits. When the desired digit appears in the display, press the setup/enter rotary
control to select and save it.
6. Scroll to and select Save to save and activate the source of Identification Tone.
7. To exit the menu, scroll to and select Exit.
56 Eclipse HX-PiCo User Guide