Clear-Com HX System Frames - Manual (Page 21)

4 Installing the
Eclipse HX-PiCo
This chapter describes how to install the Eclipse HX-PiCo matrix to a standard 19”
(48.26 cm) rack.
It also shows you how to connect the matrix to the mains power supply and external devices,
including other matrices and user panels.
Tip: For an overview of the Eclipse HX-PiCo, see 3 Overview.
4.1 Preparing to install the Eclipse HX-PiCo
4.1.1 Checking the shipment
When the Eclipse HX-PiCo is received inspect the boxes for shipping damage.
Important note:
The Eclipse HX-PiCo distributor is not responsible for shipping damage. If there is damage to
the shipment, report the damage to the carrier.
Check the packing list and verify that every item on the list has been received. Save all packing
materials in the event any items need to be returned.
4.1.2 Unpacking the System
The system comprises the Eclipse HX-PiCo matrix hardware, and the software for operating the
matrix frame.
The customer must supply:
• A standard 19 inch wide (48.26 cm) Electronics Industry Association rack in which
to install the matrix.
• A personal computer to run the EHX configuration software (see
3.5 EHX configuration software).
• Shielded CAT-5 cables to connect the matrix to user panels, interface modules,
interface frames and other intercom devices.
21 Eclipse HX-PiCo User Guide