Burkert Type 8611 - Manual (Page 14)

14
Assembly
wall assembly or rail assembly
Adapter for wall assembly Adapter for rail assembly
Tab. 1: Assembly models
7.1.1. assembly accessories
Model accessories order no.
Installation in pipeline Flow-rate fitting, Type
S030
See data
sheet S030
Rail assembly Adapter for rail assembly 655980
Wall assembly Adapter for wall assembly 427098
The adapters for the wall and rail assembly are included in the
scope of supply of the assembly model.
Tab. 2: Assembly accessories
7.2. attachment to a proportional
valve
Attach the process controller Type 8611 to a proportional valve as
described below.
→
Loosen the 4 screws at the front of the process controller.
NOTe!
Be careful when opening the process controller so as not to
damage the internal cabling.
• Remove the cover carefully from the housing without jerks.
→
Remove the cover carefully from the housing.
→
Place the supplied flat seal over the contact tabs.
→
Attach the housing of the process controller on the contact tabs
and fasten with the valve screw.
→
Check the correct position of the profile gasket at the housing of
the process controller.
→
Place cover on the housing of the process controller and fasten
with 4 screws.
If necessary, the cover can also be mounted in a position
rotated by 90 ° to the left or the right.
english
Type 8611