ALLIED Vision Technologies Oscar F-810 - Manual (Page 28)

AVT camera cleaning instructions
FireWire Hardware Installation Guide V8.0.0
28
Please carefully remove t he filter/protection glass (for certain camera
models, indicated below, requiring a special tool which can be ordered
under the following number: E9020001) and clean it on both sides using
the techniques explained below.
Not all camera types have the design to remove the filter/protection
glass. See Chapter
Changing filters safety instructions on page 20.
Camera
type Tool to be used Description
Oscar 1.3 mm hex key

(Allen key)

AVT order number

K 9020411
Loosen both countersunk screws. Remove chromatic flange: Take
care, C-Mount adjustment spacers may fall out. Put them back
carefully on chromatic flange and screw chromatic flange with
adjustment spacers in camera.
Marlin AVT order number
E9020001 Figure 3: Removing IR cut filter/protection glass using special
tool (E9020001)
on page 29
Guppy Pliers and leather Carefully unscrew the knurled ring.
Pike 1.3 mm hex key

(Allen key)

AVT order number

K 9020411
Loosen both countersunk screws (looking in front of the lens the
screws are on the top (middle) and on the right side of the
housing). Remove chromatic flange: Take care, C-Mount adjust-
ment spacers may fall out. Put them back carefully on chromatic
flange and screw chromatic flange with adjustment spacers in
camera.
Stingray • Stingray cameras
Rev. 1: see Guppy
• Stingray cameras
Rev. 2 and 3:

AVT order number
E9020001
• Stingray cameras Rev. 1:

see Guppy
• Stingray cameras Rev. 2/3: Figure 3: Removing IR cut filter/
protection glass using special tool (E9020001) on page 29
Guppy PRO AVT order number
E9020001
• Guppy PRO cameras: Figure 3: Removing IR cut filter/protec-
tion glass using special tool (E9020001) on page 29
Table 4: How to remove the filter/protection glass
Stingray Rev. 1 Stingray Rev. 2 Stingray Rev. 3
Guppy PRO