ALLIED Vision Technologies Oscar F-810 - Manual (Page 12)

Introduction
FireWire Hardware Installation Guide V8.0.0
12
Manual overview
The manual overview describes each chapter of this manual shortly.
• Chapter Contacting Allied Vision Technologies on page 6 lists AVT contact
data for both: technical information / ordering and commercial informa-
tion.
• Chapter Introduction on page 7 (this chapter) gives you the document his-
tory, a manual overview and conventions used in this manual (styles and
symbols). Furthermore you learn how to get more information on AVT
accessories, available AVT software and the AVT Technical Manuals.
• Chapter Safety instructions on page 17 describes safety instructions for
AVT cameras in general and special safety instructions for camera fami-
lies/models.
– Read this chapter carefully before operating any AVT camera.
continued from last page
V7.0.9 04.04.11 • Added Guppy PRO: Changing filter instructions same as
Marlin/Stingray: see Chapter
Marlin/Stingray/Guppy PRO:
changing filters safety instructions on page 21 and Table 4:
How to remove the filter/protection glass on page 28
• Added Singapore: see Contacting Allied Vision
Technologies on page 6
• Revised camera delay descriptions:

Chapter Stingray delay on page 51

Chapter Pike delay on page 60

Chapter Guppy PRO delay on page 67

Chapter Guppy delay on page 74

Chapter Marlin delay on page 80

Chapter Oscar delay on page 86
V8.0.0 13.08.12 Added Guppy PRO F-033, Guppy PRO F-046, and Guppy PRO F-
095C
• Chapter Guppy PRO input block diagram on page 63
• Chapter Guppy PRO delay and minimum pulse width on page
64
• Chapter Guppy PRO block diagram on page 65
• Chapter Guppy PRO delay on page 67
Changed Pike trigger input voltage
• Pike trigger input voltage (GPIn1 and GPIn2) changed from
2 V to 3 V at min. input current of 5 mA, see Chapter
Pike
camera I/O connector pin assignment on page 54.
Version Date Remarks
Table 1: Document history