Atec Agilent-E4980A - Manual (Page 32)

32
Table 57. Measurement time when Vdc-Idc is selected [ms]
Test frequency
Measurement time mode 20 Hz 100 Hz 1 kHz 10 kHz 100 kHz 1 MHz 2 MHz
SHORT 210 46 14 14 14 14 14
MED 210 170 170 170 170 170 170
LONG 410 410 410 410 410 410 410
Add the same measurement time per 1 additional average
Additional Measurement time when the Vdc and Idc monitor function is ON.
Add SHORT mode of Table 57. When using only Vdc or Idc, add a half of SHORT mode of
Table 57.
Table 58. Measurement time when Ls-Rdc or Lp-Rdc is selected [ms]
Test frequency
Measurement time mode 20 Hz 100 Hz 1 kHz 10 kHz 100 kHz 1 MHz 2 MHz
SHORT 910 230 43 24 22 22 22
MED 1100 450 300 280 270 270 270
LONG 1400 820 700 670 660 650 650
Add the three times of measurement time per 1 additional average number
Display time
Except for the case of the DISPLAY BLANK page, the time required to update the display
on each page (display time) is as follows. When a screen is changed, drawing time and
switching time are added. The measurement display is updated about every 100 ms.
Table 59. Display time
When Vdc, Idc When Vdc, Idc
Item monitor is OFF monitor is ON
MEAS DISPLAY page drawing time 10 ms 13 ms
MEAS DISPLAY page (large) drawing time 10 ms 13 ms
BIN No. DISPLAY page drawing time 10 ms 13 ms
BIN COUNT DISPLAY page drawing time 10 ms 13 ms
LIST SWEEP DISPLAY page drawing time 40 ms —
Measurement display switching time 35 ms —