Extron Electronics PowerCage FOX Tx_Rx AV User Guide - Manual (Page 37)

Figure 21. Personal Information Form
4. Follow the instructions on the rest of the download screens to download the firmware
update from the Extron website, and start the Extron Installation Program to extract
the firmware file and place it in a folder identified in the program window.
NOTE: Take note of the folder to which the firmware file is saved.
Folder where
firmware is
installed
Figure 22. Location of the Firmware File
Loading the Firmware to the Transmitter and Receiver
Downloading the Firmware Loader
To load a new version of firmware to your transmitter and receiver, you must have the
Firmware Loader software loaded on your computer. If you do not have this software,
download it from the Extron website as follows:
1. On the Extron website, click the Download tab.
2. On the Download Center page, click Software on the left sidebar menu.
3. Locate the “Firmware Loader” line and click the Download link at the far right.
Figure 23. Firmware Loader Download Link
PowerCage FOX Tx/Rx AV • Remote Communication and Control 31