This section details operation of a matrix system using an FPC 5500 front panel controller.
This section assumes that the matrix is properly installed, virtualized (for Matrix 12800
systems), and operating correctly.
The FPC 5500 software runs in an FPC computer that communicates with the matrix
switcher via a Category (CAT) 5e or higher cable, terminated with RJ-45 connectors,
between the FPC Net port and either the Ethernet port on the matrix (BME 0 on a
Matrix 12800 systems) or an Ethernet LAN on which the matrix also resides.
Control of the matrix switcher via the FPC can be password protected. There are two levels
of password protection: administrator and user. Personnel logged on as an administrator
have full access to all matrix switching capabilities and editing functions. Personnel logged
on as a user can create ties, recall presets, set video and audio mutes, and view all settings
with the exception of passwords. If the same passwords or no password is required for
logging on, all personnel log on with administrator privileges. Fields and functions that
exceed user privileges are inaccessible to users from the FPC.

NOTES:

•

The following instructions and figures are identical for all FPC 5500

compatible matrix systems (Matrix 12800, FOX Matrix 14400, and
FOX Matrix 320x), except where noted.

•

Virtual Inputs and Virtual Outputs are applicable to Matrix 12800 systems
only.