Extron Electronics FOX Matrix 14400 User Guide - Manual (Page 91)

6. After verifying that the IP address change was successful, enter and issue the arp –d
command at the Command prompt. For example:
arp –d 10.13.197.7 removes 10.13.197.7 from the ARP table
or
arp –d* removes all static IP addresses from the ARP table.
Connecting as a Telnet Client
The Microsoft Telnet utility is available from the Command prompt. Telnet allows you to input
SIS commands to the FOX matrix switcher from the PC via the Ethernet link and the LAN.
Access the
Command prompt and start Telnet as follows:
1. On the Windows task bar, click Start > Run .
2. At the Open prompt, type command .
3. Click the OK button.
4. At the Command prompt, type Telnet and then press . The computer returns a
display similar to the one shown in figure 54.
Microsoft (R) windows 2000 (TM) Version 5.0 (Build 2195)
Welcome to Microsoft Telnet Client
Telnet Client Build 5.00.99203.1
Escape Character is 'CTRL+]'
Microsoft Telnet>
Figure 54. Telnet Window
FOX Matrix 320x and FOX Matrix 14400 • Ethernet Connection 85