Extron Electronics FOX Matrix 14400 User Guide - Manual (Page 85)

Installing a Power Supply Module
NOTE: The power supply modules are hot-swappable. You do not need to power down
the switcher to install a power supply.
Install a power supply module as follows:
1. Orient the power supply module to be installed with the LED to the right.
2. Align the flanges on the power supply module with the left and right power supply
guides (see
figure 49 , on the previous page).
3. Gently slide the power supply module into the enclosure until the power supply meets
resistance.
4. Gently seat the power supply in the backplane.
5. Use a screwdriver to tighten the left and right screws to secure the power supply in
place.
FOX Matrix 320x and FOX Matrix 14400 • Maintenance and Modifications 79