Extron Electronics FOX Matrix 14400 User Guide - Manual (Page 12)

Laser controls — Non-pathologically compliant fiber optic boards can be set, via SIS
commands, to individually or globally disable the output laser drivers so that a driver does
not output light. They can also be set, individually or globally, to automatic so that a driver
turns on when a tie is made involving that driver or off when no tie is made.
Upgradeable firmware — The firmware that controls all switcher operation can be
upgraded in the field via either serial port or the Ethernet port, without taking the switcher
out of service. Firmware upgrades are available for download at
www.extron.com , and can
be installed using the Matrix Switchers Control Program or the built-in HTML pages.
Global memory presets — 64 global memory presets are a time-saving feature that lets
you set up and store input/output configurations in advance. You can then recall those
configurations when needed, with a few simple steps, via serial port or Ethernet control.
Rack mounting — Rack mountable in any conventional 19-inch wide rack.
Permanent, rechargeable battery — The matrix switcher has a rechargeable lithium
battery to track time of day when power is disconnected.
WARNING: Explosion hazard — Service note to Extron personnel: There is a
danger of explosion if the battery is incorrectly replaced. Replace it only with the same
or equivalent type recommended by the manufacturer. Dispose of used batteries
according to the instructions of the manufacturer.
ATTENTION: Non-Extron personnel must not attempt to remove the battery. Doing so
will void the warranty.
FOX Matrix 320x and FOX Matrix 14400 • Introduction 6